Eneo DMR-104 Betriebsanleitung PDF herunterladen (Seite 35)

Digital Video Recorder

NOTE: When limiting the network bandwidth, the remote watch image on the PC running RAS or WebGuard might

not be displayed properly.

The DVR supports two-way audio communication between a local system and a PC running RAS. Highlighting the

box beside Remote Audio Channel and pressing the

button allows you to select the audio channel that sends audio

to the remote site. Selecting Select From RAS will send audio of the channel selected from RAS.

NOTE: Depending on network conditions, audio might be interrupted or out of synchronization during

transmission.

Highlight Use WebGuard Service and press the button to toggle between On and Off. See Appendix – WebGuard

for detailed descriptions of the WebGuard service.

Highlight the box beside Port and press the button. Set the port number used when accessing WebGuard by using

the Up and Down arrow buttons to increase or decrease the numbers.

Highlight Use SSL for Transferring Data and press the button to toggle between On and Off. When it is On, the

security of data except video and audio transmitted for remote monitoring or remote recording can be enhanced by

using the SSL (Secure Sockets Layer) authentication. When using the SSL function, the DVR cannot be connected

with a remote program or a network keyboard which does not support the SSL function.

CAUTION: The remote connection will be disconnected temporarily after changing the SSL settings.

NOTE: This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit

(http://www.openssl.org/).

IP Address

Highlight IP Address and press the

button, and the IP Address setup screen displays.

Figure 19 : Network – IP Address (Manual) setup screen.

Highlight the box beside Type and press the

button. You can select the type of network configuration from:

Manual, DHCP and ADSL (with PPPoE). Select the desired type and press the

button.

Selecting Manual from the Type allows you to set up LAN parameters manually.

Change the numbers by highlighting them and using the Up and Down arrow buttons to increase or decrease the

number. The factory default LAN settings are:

IP Address: 192.168.1.129

Gateway: 192.168.1.254

Subnet Mask: 255.255.255.0

NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network

administrator.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 87 88

Keine Kommentare

Eneo DMR-104 Betriebsanleitung Seite 35