Eneo DLR3-08N/160CD Spezifikationen PDF herunterladen (Seite 46)

Installation of DVR4 protocol when many DVR use

BAUD RATE

DOME1 : 9600

DOME2/DVR : 9600

MUX/KBD : 9600

DVR/AUX : 9600

ALARM/AUX : 9600

SAVE AND EXIT

PORT DEFINITIONS

DOME1 : NONE

DOME2/DVR : DVR4

MUX/KBD : NONE

DVR/AUX : NONE

ALARM/AUX : NONE

SAVE AND EXIT

When you control PTZ cameras on many DVRs, you need RS-232 to RS-485 converter. PTZ cameras are connected to RS-232 to RS-485 converter by the

RS-232 port of the DVR and the keyboard is connected through the RS-485 port of the DVR. Follow as below.

1. Connect RS-485 cable between RS-485 Port of DVR and the DOME1 port of the J-box.

2. Connect RS-485 cable to the RS-485 Ports of DVRs.

3. Connect RS-232 cable between RS-232 Port of DVR and the RS-232 Port of the RS-232 to RS-485 converter.

4. Connect PTZ cameras to the RS-485 Port of the RS-232 to RS-485 converter.

5. Repeat the step 3-4 each DVR.

6. Set the system ID number of each DVR from 1 to the last DVR increasing 1.

7. Set the network menu of the keyboard as below.

NOTE: The baud rate of DOME1 should be the same as one of the RS-485 of the DVR.

8. How to setup DVR:

A. Switch the DVR on.

B. Enter the Menu according to the DVR’s instruction manual.

C. Change the Port to „RS-485” of the remote control in the devices menu.

D. Conﬁrm matching the setup of RS-485 with the keyboard.

(Ex: Baud Rate:9600, Data Bit:8, Stop Bit:1, Parity:None)

E. Change the Remote Control to „Remote Control2” in the devices menu.

F. Change the Port to „RS-232” in the PTZ menu of the camera of the devices menu.

G. Conﬁrm matching the setup of RS-232 of the PTZ menu with PTZ cameras.

H. Set the PTZ menu according to PTZ cameras. (PRODUCT and ID)

NOTE: The baud rate of all PTZ cameras should be used one speed type (ex. All 9600 or all 2400)

1 2 ... 41 42 43 44 45 46 47 48

Keine Kommentare

Eneo DLR3-08N/160CD Spezifikationen Seite 46